Common faults and troubleshooting methods of Electric Sprayer

Electric Sprayer is the abbreviation of electric sprayer material. Electric Sprayer is a device that uses air suction to turn potions or other liquids into mist and spray them evenly onto other objects. It is generally called Electric Sprayer drove by manpower or a small battery machine, and a sprayer is driven by an engine.

Here is the content list:

• Electric Sprayer Insufficient spray pressure

• Electric Sprayer does not mist

• Improper connections between components of the Electric Sprayer

Electric Sprayer Insufficient spray pressure

If the inlet valve is erected by dirt, remove the inlet valve and wipe off the dirt with a cloth; if the leather bowl is damaged, the leather bowl can be replaced with a new one; if the sealing ring is not installed at the connection part, or the sealing ring is damaged if there is air leakage, the sealing ring can be installed or replaced. Because most pesticides have a certain corrosive effect on Electric Sprayer, after stopping use, it should be washed with alkaline water in time, and then rinsed with clean water, especially after spraying the Bordeaux mixture, it is best to soak in alkaline water for 1-2 hours, because the Bordeaux liquid is very corrosive, which can effectively increase the service life of the electric sprayer.

Electric Sprayer does not mist

If the oblique holes of the nozzle body of the Electric Sprayer are blocked by dirt, the oblique holes can be cleared; if the nozzle holes are blocked, they nozzle holes can be disassembled for cleaning, but hard objects such as iron wires or copper needles cannot be used to poke the nozzle holes to prevent the holes from expanding. Make the spray quality worse; if the filter screen in the electric sprayer casing is blocked or the water valve ball is put up, the filter screen and the dirt on the ball should be cleaned. Be careful to prevent rust after use. All removable parts must be removed and cleaned. The inner pipe wall of the spray rod and spray head of the Electric Sprayer should be washed with oil to avoid moisture and rust, which can effectively reduce the increase of dirt.

Improper connections between components of the Electric Sprayer

If the switch cap of the Electric Sprayer is not tightened, the switch cap should be tightened; if the washer on the switch core is worn, the washer should be replaced; the switch cannot be screwed because it has been placed for a long time or used for a long time, and the switch core is due to the chemical If it is etched and adhered, the parts should be removed and cleaned in kerosene or diesel; if it is difficult to remove, it can be soaked in kerosene for some time, and then removed to remove it. Do not hit the Electric Sprayer with hard objects. If the connection parts of the electric sprayer are leaking, if the joint is loose, tighten the nut; if the gasket is not flat or damaged, flatten the gasket or replace the gasket; if the gasket is dry and hardened, it can be soaked in animal oil Use after softening.

Our official website is www.gfsprayer.com. If you work with Electric Sprayer or want to know more about our company, you can communicate with us on the site. Our cost-effective products are highly praised by everyone.